Creating initial configuration for ArubaOS-CX
=============================================

* Wait for the 'login' prompt
* Login as 'admin' (no password)
* Set the new 'admin' password as 'admin'
* Save the initial configuration with 'write memory'
* Reload the device with 'boot system'
* Login as 'admin' password 'admin'
* Copy-paste the following configuration

=============================================

configure
!
user netlab group administrators password plaintext netlab
user netlab authorized-key ssh-rsa AAAAB3NzaC1yc2EAAAABIwAAAQEA6NF8iallvQVp22WDkTkyrtvp9eWW6A8YVr+kz4TjGYe7gHzIw+niNltGEFHzD8+v1I2YJ6oXevct1YeS0o9HZyN1Q9qgCgzUFtdOKLv6IedplqoPkcmF0aYet2PkEDo3MlTBckFXPITAMzF8dJSIFo9D8HfdOV0IAdx4O7PtixWKn5y2hMNG0zQPyUecp4pzC6kivAIhyfHilFR61RGL+GPXQ2MWZWFYbAGjyiYJnAmCP3NOTd0jMZEnDkbUvxhMmBYSdETk1rRgm+R4LOzFUGaHqHDLKLX+FIPKcF96hrucXzcWyLbIbEgE98OHlnVYCzRdK8jlqm8tehUc9c9WhQ==
!
ntp vrf mgmt
ssh server vrf mgmt
!
interface mgmt
  no shutdown
  ip dhcp
!
https-server vrf mgmt
!
end

=============================================

* Save the configuration with 'write memory'
* Reload the device with 'boot system'
* Verify that the startup- and running config contain the above configuration
  commands. Repeat the 'configure, write, reboot' cycle if needed
* Check that the management interface is up and has an IP address 
* Disconnect from console (ctrl-] usually works).
* Shutdown the VM, if needed
